|
Romy the Cat's
personal site dedicated to advanced audio and evolved music reproduction
techniques
|
|
|
|
|
Despite the tremendous popularity of the single-ended amplifiers have a certain group of audio people, let to be honest: the SETs do not sound REAL in audio people’s listening rooms. I was in many of those listening rooms and have heard many best SET...
|
I am using the Celestion Axi-periodic compression driver in the KLIPSCH K402 horn which I have boosted considerably when I noticed that the top one and one-half octaves were barely working when playing music so I figured WHY NOT? and it works just f...
|
Mani,
I would leave the subject of DSET/horn setup for another thread and would drop a few words about Zu Druids. They are not the speakers that I would ordinary comment but since I have a local guy with Zu Druids and I had a chance to hear th...
|
This is classical common mode noise interference on a common supply. This type of noise will pass right through any power conversion technology and in both directions. Due to the timing variations, I would expect it to be a little bit of mains inte...
|
Romy, in the contrary, it is very unfair to compare my 845 amp with the 6C33C. The main reason is the 845 amp used the best output/interstage transformer available, while the 6C33C's output xformer is pretty good but far from being best for the 6C33C...
|
[quote user="Romy the Cat"]Again, it was very interesting, but… Let agree that methodologically you did not try Placette as it performance was masked out by you need to use your Neurochrome buffer to get gain. Your chain will sound as the worst eleme...
|
[quote user="Paul
S"]If you said anything about your 15" VitaVox in the video, I
must have missed it. What frequency range are you running them, and what
is low-pass filter? Given your prejudices, I suppose the cabinets are sealed,
so they can't...
|
I spent many hours listening and experimenting, trying to change the signature of my mid-base channel. Everything that I'm trying suggest me that I am in at very right direction but I am still not server I would say freeze the system and do not t...
|
W,
Be careful with Milq’s LF channel. When you go for a dedicated LF SET and make the SET to operate very low then you need very precisely dial in the loading of your out tube with the behavior of your LF drivers/enclosure. Without know the very spe...
|
[quote user="Dominik"]You probably decline this option, because this horn is from plasctic ( You can take carbon horn also).Polish autotech make Iwata 300 for me. You Can order from them what You want.[/quote]
Yes, the Iwata horns are good as ...
|
I have been playing around with speakers for a long time, and things started snapping when I got into horns. I have a system right now with an upperbass horn from 140 hz turned form MDF up to around 700 hz, to another horn, and another and a super t...
|
Well, Nerone, the differences between any tuners would greatly vary with signal, not even with the strength of signal but rather with the specific location and surrounding of a given station. To make the things conceptually right it wou...
|
[quote user="nl"] Within that horn-loaded range, the 210/515 type combo does reasonably well, and produces rather more inspirational midbass than most direct-radiator type strategies. There is a reason why these designs persisted for roughly forty ye...
|
I know many would view the two frequencies as similar and perhaps of little consequence, but I have my reasons.My primary, driving objective for wanting the horn to produce sound faithfully to at least 90Hz is that 90Hz represents an ideal crossover ...
|
Yes, it turned out to be the emails from GOTO importer. I am not completely understood if the horn at the picture above is an official GOTO product. The Ming Su said that the horn was build locally by Jeffrey Jackson with the support of GOTO but then...
|
Romy wrote:"Do not listen
Romy, make you own very simple experiment and then make your own mind.
Take two horn channels, low-pass and high-pas them at 6K for instance
and drive them with 6K sinewave. When you time alight the driver you
have well ...
|
Oh, rowuk, you have no idea how much I agree. To me passive theaters very much like ports and I hated anything which stay even remotely close to it. However, this time the entire Remedios project is is very different s s is built not based upon knowl...
|
Recently, I would say the last 2-3 years, I detected a very foolish tendency that audio people are brewing within themselves. A typical today’s audiofool holds within itself a hope about existing of a “secret”, no discovered yet, SS high power amplif...
|
[quote user="Thorsten"]I wonder, which specific line level interstage transformers have you tried, it would have to be ALL of them in order for your statement "there are non" to hold.......But, what specifically do you object to in these transformers...
|
[quote user="drdna"]I have found the next obvious glaring problem, which is contributing to the muddy sound I described earlier. There is a mismatch between the two channels. The right channel is very slightly softer than the left with a ...
|
Perrew,
LCR is not active at all; it is the very same passive EQ as your RC? I think you a bit confused with terminology. The main logical explanation (there are many of them) is that capacitive filtration is very bad one and need to be minimi...
|
Romy wrote :"...It is most likely that you changing the yours crossover to 4800Hz introduced a phase shift that accidentally “clicked” with the neighboring channels...You might look at the differences in imaging since you changed the crossover..."
H...
|
It is amassing what kind of tricks the Fundamentals Channel allows to play. Since my high-frequency Vitavox S2 driver “clicked” recently:
http://www.goodsoundclub.com/TreeItem.aspx?PostID=3592
my “Fundamental Channel” with my LF Vitavox S2 al...
|
I am really enjoying myself here at Romys site. I like the idea of someone documenting their efforts in a very (self) critical way.I think that anyone solving issues in a methodical way uses similar techniques. They all involve stripping the problem ...
|
Yes, I agree. If the output of the fundamentals-channel is controlled via the slopes in the crossover, the opportunity to set the output on a recording-to-recording basis is lost. If one, however, has the output of the fundamentals-channel ...
|
Despite the fact the I lost the quality of the lower knee of my midbass horn (I guess the primary resonance went all the way down) I keep trying to catch the right termination of midbass low pass filter. I bought those expensive 20H coils and added ...
|
…or the “The new Channel”: some observations after the game.
This thread is organic derivation of the multi-paged thread:
http://www.goodsoundclub.com/TreeItem.aspx?postID=2433#2433
First of all: despite that I got some preliminary positive result...
|
Chris,
I head a lot a lot of good thing about Pieter from Tribute and I would like to recruit him for the s2 transformer. We send last week to him an email and he did not reply. I heard from many other people that it is a very typical for his commu...
|
Hi Romy,I see why you don't like the design. And in particular, the choice of where he chose to limit the frequency responses for the two channels. I see the benefit of the DSET approach in this context as you explained it. If I understand you, your ...
|
OK, the amp is running for the 6C41C for a few days and it looks like the tube should be burned-in sufficiently enough for now. Still I have to note that the sound of 6C41C was not changed since my initial listening of this tube.
Originally I drove ...
|
|
|
|
All context of this site except the Forum's posts
Copyright © Roman Bessnow 2004-2024
All messages within the Site’s Forum Copyright © by
authors of the posts
|
Last 24-hours posts: |
1 |
|
|
|
Total human visitors: |
43,015,918 |
|
|
|
|
|
|