| Search | Login/Register
   Home » Horn-Loaded Speakers» Replacing 802 G and 811 horns (3 posts, 1 page)
  Print Thread | 1st Post |  
Page 1 of 1 (3 items) Select Pages: 
03-08-2016 Post does not mapped to Knowledge Tree
Sean19
Posts 5
Joined on 02-24-2016

Post #: 1
Post ID: 22558
Reply to: 22558
Replacing 802 G and 811 horns
fiogf49gjkf0d
Hi i want to replace my 802 G drivers with something that plays flat and has extended highs. I have several horns was thinking of using Radian drivers like the 1.4"  745pb i have some 800hz 1.4" tractrix horns to mount them on.  Anyone have experience with Radian? any recommendations? How about going three way with coaxial BMS drivers. Or do i just use a larger 1.4" altec and a good horn tweeter? all opinions appreciated. 
03-08-2016 Post does not mapped to Knowledge Tree
Paul S
San Diego, California, USA
Posts 2,571
Joined on 10-12-2006

Post #: 2
Post ID: 22559
Reply to: 22558
In Order
fiogf49gjkf0d
to get worthy advice, perhaps you could share some info about your present system and musical tastes, also what it is you like and don't like about your present set-up, and how you'd like to change it, beyond "flat + extended highs". If you have read the site, you know that mixing and matching horns and drivers is an expensive hobby with no guaranteed outcomes. If you've not read the site, I recommend that as a good starting point. Although you might not get the sort of specific, off-the-wall recommendations you'll get from other forums, you might actually wind up with a better understanding of how to get what you want. Anyone might say, "try the JBL 375", but that's hardly enough to go on, thus no real help, if you are at loose ends.




Best regards,
Paul S
03-08-2016 Post does not mapped to Knowledge Tree
rowuk


Germany
Posts 438
Joined on 07-05-2012

Post #: 3
Post ID: 22560
Reply to: 22558
Extended highs......
fiogf49gjkf0d
I think that most of us here consider horns to be decade devices. That means about 3.5 octaves can be optimally covered. 800-8000Hz in your case. Extending the "highs" another octave means a couple of things. If a horn is "too short" you do not get much EQ or benefit for the lower octaves. If it is too long, it acts like a transmissionline, the response gets ragged (also to the ear). That means a horn that does a good job at 1K could (and most likely would) be pretty challenged at 10K. I know that there will be a bunch of Constant Directivity users that will scream that this is not true. If that is what they want to believe, then fine. Coax solutions are maybe great for PA, but the long horn for the mids will screw up the top octave for sure.

If Sound quality is your goal, you need to figure out if the Altec 802 on your tractrix horn has serious Sound from 800Hz to whatever. If yes, then an additional channel above 8-10KHz (not necessarily a horn) could be a solution.
I have experience with the BMS coax. I bought them, broke them in, and they were in my system for 2 days. I sent them back. Coax does not work in my opinion. You can get nice pressure response, but that is not my goal.


Whenever I feel blue, I start breathing again.
Page 1 of 1 (3 items) Select Pages: 
Home Page  |  Last 24Hours  | Search  |  SiteMap  | Questions or Problems | Copyright Note
The content of all messages within the Forums Copyright © by authors of the posts