| Search | Login/Register
   Home » Melquiades Amplifier » Inside views of "melquiades" (2 posts, 1 page)
  Print Thread | 1st Post |  
Page 1 of 1 (2 items) Select Pages: 
01-10-2006 Post does not mapped to Knowledge Tree
AnonymousUser
Posts 19
Joined on 11-27-2004

Post #: 1
Post ID: 1927
Reply to: 1927
Inside views of "melquiades"

buy naltrexone

buy low dose naltrexone canada

abortion clinics in orlando for cheap

cheap abortion in chicago avonotakaronetwork.co.nz
hi-i have downloaded the circuit diagram for your amp but wondered if you have any photos of the "guts" so i can see how you laid yours out ?
just a couple of questions
1- R3 + R24-27 are shown not in bold print-why ?
2-it says "look below for OPT"-?
3-are OA2 like a zener diode ?and would a zener diode do in these positions.
regards Philip
01-10-2006 Post does not mapped to Knowledge Tree
Romy the Cat


Boston, MA
Posts 10,049
Joined on 05-28-2004

Post #: 2
Post ID: 1928
Reply to: 1927
Re: inside views of "melquiades"

mirtazapine alcohol withdrawal

mirtazapine overdose cogimator.net

viagra prodej praha

viagra

 AnonymousUser wrote:
hi-i have downloaded the circuit diagram for your amp but wondered if you have any photos of the "guts" so i can see how you laid yours out ?

I do not have a full rage Milq anymore. I have only the 3-chanals Super Milq, this is juts the amp section with the PS. I do not think that it would be necessary to imitate any my or anyone else layout as the Milq id very simple and you could come up with your own arrangement. There are some very few layout issues in the Milq that “must” but they are juts the common since of any amp’s layout….

 AnonymousUser wrote:
just a couple of questions
1- R3 + R24-27 are shown not in bold print-why ?

The R3 is an optimal resistor to drive current via the cable if you need to. The R24-27 are the virtual filaments ground resisters. The are also optimal and if you have no LF noise then you do not need to use them

 AnonymousUser wrote:
  2-it says "look below for OPT"-?

Read the http://www.goodsoundclub.com/Melquiades.aspx

 AnonymousUser wrote:
  3-are OA2 like a zener diode ?and would a zener diode do in these positions. "

Nope, use OA2 gas tube. I am not responsible for the result you get with zener diodes. There were a lot of reasons to use in the Milq what was used. If you want to have Melquiades then stick to what have done. If you want to design your own amp and your own sound then feel free to do so but it has no relation to something that I endorse

Rgs,
Romy


"I wish I could score everything for horns." - Richard Wagner. "Our writing equipment takes part in the forming of our thoughts." - Friedrich Nietzsche
Page 1 of 1 (2 items) Select Pages: 
Home Page  |  Last 24Hours  | Search  |  SiteMap  | Questions or Problems | Copyright Note
The content of all messages within the Forums Copyright © by authors of the posts