GoodSoundClub - Romy the Cat's Audio Site

In the Forum: Analog Playback
In the Thread: Copper Mat on a Micro Seiki Gun Metal Platter

Post Subject: Stainless steel platter for Micro RX-5000Posted by measet on: 8/23/2017

Hi Wellington,

Also I'm thinking to make a stainless steel platter for my RX-5000.
As you have good experience with yours could you tell me the exact parameters of the new design (beveled insight edge, thicker deck part). The schematic would be the best.
I was looking for the 316L material, I found the needed diameter but all of them have a very small reaction to magnet what I think is slightly unfortunate close to the cartridge area. Have you experience with this isue?

Thanks a lot!

Rerurn to Romy the Cat's Site