Rerurn to Romy the Cat's Site
In the Forum: Analog Playback
In the Thread: Micro RX5000: is that bearing spins normally?
Post Subject: Bearing/Shaft vs. PlatterPosted by Paul S on: 2/5/2014
fiogf49gjkf0d
The bearing might be fine and one would see up-and-down at the platter rim if the (sub-)platter was not a constant, perfect 90 degrees relative to the bearing shaft, through the 360 degrees of rotation. Many ways misalignment might happen, only a few ways to make it right again. Not a DIY repair, I suspect.
Paul SRerurn to Romy the Cat's Site