GoodSoundClub - Romy the Cat's Audio Site

In the Forum: Analog Playback
In the Thread: About EAR 834P Modifications

Post Subject: Bleeder resistors.Posted by valves on: 11/24/2009

Thanks for the reply. My 834 came from the factory without the 220k ohm resistors. I was wondering if I should go ahead and add them while I still have the unit apart. I purchased Caddocks for the repalcements but alas no where to put them without adding a few holes in the board, or maybe some other kind of bandaid. Also curious as to the other 6 resistors R18 and R118, R17 and &117, and R19 and R119. The last four seem to be connected to the output traces and ground. None of these resistors are on the available schematics, I may be parting hairs here, just wondered what I leave them in or take them out, Thanks again, Valves

Rerurn to Romy the Cat's Site